Skip to Content

Condition Description

For sliding parts such as gears, bearings and guide rails, the deciding properties are friction coefficient, wear rate and creep resistance - not strength or temperature alone. Engineering plastics replace metal in oil-free, low-noise and corrosion-resistant applications, but under high load and high surface speed they fail through frictional heating, so the PV limit and heat dissipation must be checked together.

This page ranks candidates by wear resistance, low friction, strength and stiffness. POM offers good stiffness, dimensional stability and low friction and is the default for gears and small bearings; PA66 is tougher but changes dimension with moisture; UHMW-PE wears extremely well but has low stiffness, suiting guide liners rather than precision gears.

Candidate Materials for This Condition

12 products matchedAll mandatory criteria met
See excluded products (4) and reasons
  • PPO板(改性聚苯醚)|低介电2.65 耐热137℃|电气绝缘Long-term temperature 10 below required 80 °C
  • PPO棒|低介电高刚性|高频绝缘与化工件加工Long-term temperature 10 below required 80 °C
  • 导电PA尼龙板|10³–10⁵Ω全断面导电|半导体载具Long-term temperature 10 below required 80 °C
  • 导电PA尼龙棒|10³–10⁵Ω|防静电工装与传动件Long-term temperature 10 below required 80 °C

Your selection criteria: Long-term service temperature ≥ 80 °C

or contact us directly

69 products match this condition. To filter by your specific parameters, use the Full Material Selector →

Basis for Judgment and Key Points

FAQ

For quiet-running gears, POM or PA66?

Both are common. POM has higher stiffness, lower friction and better dimensional stability, which suits precise transmission gears. PA66 is tougher and damps noise better, which suits impact-loaded or coarse-pitch gears, at the cost of moisture-driven dimension change.

UHMW-PE is so wear resistant - why not use it for gears?

Its wear resistance comes from very low surface friction and self-lubrication, but stiffness, creep resistance and load capacity are all low, so it deforms and cannot hold tooth accuracy. It suits large-area, low-load sliding parts such as guide liners and hopper linings.

Can plastic gears replace steel gears?

At moderate load and moderate speed where noise reduction or corrosion resistance matters, yes, and lubrication can be eliminated. For high load, high speed or high temperature, no - frictional heat accumulates and the tooth flank wears rapidly or even melts.

Smart Material Selection