MC浇铸尼龙板|高韧性耐疲劳|齿轮齿条传动件用
100% match- Long-term temperature 115 exceeds your 80 °C requirement
Item-by-item check against your criteria
| Long-term Working Temperature | 115 | ✓ |
|---|
Ranked by wear resistance, friction and creep, this page lists candidates for gears, bearings and slide plates, and explains where POM, PA66 and UHMW-PE each fit.
For sliding parts such as gears, bearings and guide rails, the deciding properties are friction coefficient, wear rate and creep resistance - not strength or temperature alone. Engineering plastics replace metal in oil-free, low-noise and corrosion-resistant applications, but under high load and high surface speed they fail through frictional heating, so the PV limit and heat dissipation must be checked together.
This page ranks candidates by wear resistance, low friction, strength and stiffness. POM offers good stiffness, dimensional stability and low friction and is the default for gears and small bearings; PA66 is tougher but changes dimension with moisture; UHMW-PE wears extremely well but has low stiffness, suiting guide liners rather than precision gears.
| Long-term Working Temperature | 115 | ✓ |
|---|
| Long-term Working Temperature | 115 | ✓ |
|---|
| Long-term Working Temperature | 85 | ✓ |
|---|
| Long-term Working Temperature | 85 | ✓ |
|---|
| Long-term Working Temperature | 95 | ✓ |
|---|
| Long-term Working Temperature | 95 | ✓ |
|---|
| Long-term Working Temperature | 85 | ✓ |
|---|
| Long-term Working Temperature | 85 | ✓ |
|---|
| Long-term Working Temperature | 90 | ✓ |
|---|
| Long-term Working Temperature | 90 | ✓ |
|---|
| Long-term Working Temperature | 250 | ✓ |
|---|
| Long-term Working Temperature | 250 | ✓ |
|---|
Your selection criteria: Long-term service temperature ≥ 80 °C
or contact us directly69 products match this condition. To filter by your specific parameters, use the Full Material Selector →
Both are common. POM has higher stiffness, lower friction and better dimensional stability, which suits precise transmission gears. PA66 is tougher and damps noise better, which suits impact-loaded or coarse-pitch gears, at the cost of moisture-driven dimension change.
Its wear resistance comes from very low surface friction and self-lubrication, but stiffness, creep resistance and load capacity are all low, so it deforms and cannot hold tooth accuracy. It suits large-area, low-load sliding parts such as guide liners and hopper linings.
At moderate load and moderate speed where noise reduction or corrosion resistance matters, yes, and lubrication can be eliminated. For high load, high speed or high temperature, no - frictional heat accumulates and the tooth flank wears rapidly or even melts.